Add a Static Route on CentOS – eSecureData Inc.

Adding a static route to a different subnet that cannot be accessed through your default gateway.

To add a temporary route:

To make it persist system or network settings restart, create a route-ifname file for an interface through which the subnet is accessed, in this case eth0:

Add the line with the network settings for the other subnet:


If your computer is on a network and is not directly connected to the internet, it will be configured with what is called a default gateway, which is usually a router. If the computer cannot find the specific IP address on its local network (aka broadcast domain), as defined by its subnet, it will forward any packets headed to that IP address to the default gateway. The gateway will then attempt to forward packets elsewhere, such as the internet, or another broadcast domain.

But what if you have a separate network (i.e. another office department) that is NOT accessible via the default gateway?

For example, your internet router may be located at and it is serving your local network, However, you have a /24 network that is accessible only through a secondary router, which has the IP address on the main network. Therefore, you need to point your OS to the secondary router for any IP addresses located in the address space. To do this, you need to add a static route.

Add a temporary static route

If you wish to add one temporarily, simply run the ip route add command with the right network information: is the network you wish to access.
/24 is the subnet mask is the secondary router to which you are adding a default route
eth0 is the network interface assigned to your main network (in this case,

ip route add command will only persist until the next reboot or interface/network settings restart.

Add a permanent static route

To make the route permament, you need to create a static route configuration file. Create a file with the name route-interface in /etc/sysconfig/network-scripts, such as:

Then, add the same line you would with ip route add:

Make sure to restart your network settings so they take effect:

If you lose your internet connection

If you suddenly cannot connect to the internet after adding a static route and are using static IPs (as opposed to DHCP), you may not have your default gateway configured correctly. Add it to your /etc/sysconfig/network file:

Source: Add a Static Route on CentOS – eSecureData Inc.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.